Change Camera Resolution for Camio (Camera on main LAN)

Change Camera Resolution for Camio (Camera on main LAN)

If your camera is connected directly to your router with other devices on your network, it can be accessed through the "Boxes" page on the Camio website. From there, we can log into the camera and change the resolution 

1. Log in to your Camio account.
   
2. Click the account email in the top right corner, then select the "Boxes" option from the menu.
   
3. Each of the cameras connected to your account will be displayed. Click the "Show password" checkbox and take note of the "Username" and "Password" fields. You will need them momentarily.
   
4. Underneath the camera you wish to configure, click the "Open xxx.xxx.xxx.xxx" button. The exact sequence of numbers depends on your network and will not be the same set listed here.
   
5. The camera login page should show up. Log in with the credentials found in step 3.
   If the page does not load, your camera might be located on a CamLAN through another service such as Eagle Eye. If this is the case, you must access the camera through their interface instead.
   
6. Click the "Configuration" button located at the top of the page.
   
7. From the menu on the left, select the "Video/Audio" section. On that page, use the dropdown to change the Resolution to 1280*720P.
   

Be sure to click the "Save" button or your changes will be discarded!

• Related Articles

• Change Camera Resolution

  The third tab in the camera settings is for Resolution. There you can change settings for the preview stream and full video stream. The preview stream is a low resolution image updated once a second. The full video settings are for live streaming and ...

• Camio Hardware Installation Guide

  Camera Angle Whether a camera was purchased specifically for your tailgating solution or you are using cameras from an existing system, certain guidelines regarding the camera angle must be met in order to have accurate results. Please install or ...

• Change Camera Settings

  You can access camera settings from the Dashboard using the gear icon, or using the drop-down menu on the camera’s preview video.

• Eagle Eye - IP Camera Connectivity Troubleshooting

  In the event one or many cameras (but not all) go offline, please perform the following procedures: Eagle Eye Connection Diagram Reboot the Eagle Eye system. Do the following in this order: Unplug the power for the Eagle Eye unit Unplug the power for ...

• Change Door Access Within a User Group

  Overview Groups define who has access to which door and when.  Users are assigned to at least one group.  If a user isn't assigned to a group, that user will not have access to any doors.  The following instructions demonstrate how to add and remove ...